Connecting To Devices Which Control The Projector - JVC DLA-M5000LU Instructions Manual

Connecting to Various Devices (Cont.)

Connecting to Devices which Control the Projector

Before connection, be sure to turn off both the projector and devices to be connected.
• Read the manual thoroughly which comes with each device to be connected.
• By connecting a computer to the RS-232C terminal, you can control the projector.
* For details, consult an authorized your dealer or service center.
• If you connect the cable terminal of the remote control and the REMOTE terminal of the projector with a remote control cable,
you can use the remote control in a place or at an angle from which the infrared beam cannot reach the projector.
• Desktop type
• Note type
• Remote control (when remote control cable is used)
22
To RS-232C connector
RS-232C reverse connection
cable (separately available)
To RS-232C connector
To remote control
cable terminal
RGB IN-1
RGB
R RGB IN-2
G
B
RGB OUT
To RS-232C connector
To REMOTE terminal
Remote control cable
Y/C V
EXT. IN
H/C
S
V
REMOTE
CON
RS-232C