Table of Contents
Advertisement
Controls and Features
Rear Side/ Right Side/ Bottom Surface
q
Connector Panel
w
Speaker
7
Air Inlet
q
Connector Panel
For details, refer to 'Connector Panel'. (☞ page 9)
w
Speaker
Built-in speaker located here.
e
Lamp Cover
Remove this cover when replacing the lamp. (☞ page 47)
r
Exhaust Vent
Warm air is expelled through these vents to keep the sys-
tem cool. Please do not block the exhaust vents.
8
e
Lamp Cover
t
Remote Sensor (Rear)
r
Exhaust Vent
Bottom Surface
7
Air Inlet
u
Filter
i
Rear Fixed
Foot
t
Remote Sensor (Rear)
When operating with the remote control, aim it towards this
sensor. (☞ page 18)
• A remote sensor is also provided at the front of the pro-
jector.
y
Front Adjustable Foot (for adjusting the height and
angle)
It is set at the lowest position when shipped from the fac-
tory. The foot can be adjusted to a maximum angle of +6°
and a maximum length of 31 mm. (☞ page 15)
u
Filter
Cleans air drawn in from the air inlet. Please clean the filter
regularly with e.g., a vacuum cleaner. (☞ page 50)
i
Rear Fixed Foot
y
Front Adjustable
Foot
Blocked as it is not in use.
Opening it forcibly will cause
damage to the machine.
Advertisement
Table of Contents
