Editing Morphs; Morph Programming Latch - Clavia Nord Lead A1 User Manual

14 | Nord Lead a1 User MaNUaL v1.3x

Editing Morphs

Edit a parameter's Morph range:
• Hold the Morph Source button and turn the destination knob to a
new position.
Clear all parameters assigned to a Morph Source:
• Hold Shift and press the Morph Source button that is to be cleared.
Clearing one parameter from a Morph:
• Hold the Morph Source button and turn the parameter knob to its
original position. The green parameter Morph LED will be switched
off.
• Double-click on a Morph button to latch the Morph, then hold Shift
and turn the knob of the parameter you wish to clear.
Copy and paste a Morph setup
• Hold Copy and press the Morph button that is to be copied to the
CPy
virtual clipboard. "
Paste, then press the destination Morph button. "
in the display.

Morph Programming Latch

Morphs can be latched, making it possible to lift your finger off the
Morph button while setting up the Morph. It provides a great overview
that can simplify setting up and adjusting multiple Morph Destinations
at once.
1
Double-click on one of the Morph Source buttons.
The Morph Source button flashes continuously, and green LEDs
on the panel will show any of the parameters that are assigned to
this Morph source.
2
Operate a parameter that you want to be Morphed.
Press any of the Morph Source buttons to exit Morph Latch
Mode.
" will be shown in the display. Hold Shift and
Pst
" will be shown