Editing Programs
4. Editing Programs
Changing An Existing Program
Actually, how to change a programmed sound can be described in one sentence: "twist the knobs and
press the buttons". It is as simple as that!
For information about editing Percussion Kits, refer to page 30.
Don't be afraid to edit and overwrite the RAM Programs in the internal memory (Program 01 - 40). If later
you want to restore any of the original RAM factory programs, they are backed up as ROM Performances
as described on page 106.
Changing One Sound In A Layer
If you have layered sounds you can still edit one of the sounds from the front panel. Proceed as follows:
1. Press the Program Slot button that you want to edit.
Its LED will flash to indicate it is the active slot.
2. Use the front panel to change the sound.
Getting Back To The Programmed Sound
If you have edited a Program and want to get back to the programmed original, proceed as follows:
1. Select another Program for that slot.
2. Select the first Program again.
It will now have reverted back to the way it was when you selected it last.
Page 21