Table of Contents
Advertisement
E1–60
(2) Drum, brake
1. If the drum cannot be removed because it has seized to
the rear axle hub & bearing Assy, screw two appropriate
bolts (M6)1.00) into the screw holes of the drum and
remove it.
(3) Hub & bearing Assy, rear axle
1. Remove the bolt retaining the hub & bearing assembly, using a long Torx wrench T55.
TOOL: Long TORX
2. Slowly pull out the hub & bearing assembly from the rear suspension arm assembly. Disconnect the
connector from the speed sensor wire.
13-1-5
INSPECTION
(1) Contact between brake shoe lining and brake drum
1. Apply chalk to the inner surface of the drum. Slide the
lining, while it is being pressed against the inner surface
of the drum. If poor contact is present, be sure to grind
the lining.
SPECIFIED VALUE: No significant poor contact is
present.
2. Be sure to wipe off the chalk.
(2) Cylinder Assy, disc brake, rear
1. Check the cylinder assembly for corrosion and damage.
(3) Plate S/A, brake backing, rear RH/LH
1. Check the plate subassembly for wear and damage.
13-1-6
POINTS OF INSTALLATION
(1) Hub & bearing Assy, rear axle
1. Connect the connector of the speed sensor wire to the hub & bearing assembly. Then, install the hub
& bearing assembly to the rear suspension arm assembly.
2. Secure the hub & bearing assembly and brake backing rear plate subassembly RH/LH, using a long
Torx wrench T55.
TOOL: Long TORX
(2) Drum, brake
1
.Insert a flat screwdriver through the shoe adjusting hole
of the RH/LH rear brake backing plate S/A and turn the
RH/LH automatic adjusting ratchets by . In this wAssy,
release the engagement with the RH/LH automatic ad-
justing lever S/A. Then, fully contract the brake shoe
Assy No. 3 at the leading side and the trailing side. Un-
der this condition, install the drum into position.
®
wrench T55
®
wrench T55
M21C7063T10
M21C7064T10
M21C7068T10
Hide quick links:
Advertisement
Table of Contents
