Table of Contents
Advertisement
|
16
Initial use
3.3.2
Connections and buttons
On the tuner
The product is very easy to use. Therefore, the device has just a few connections:
b
b
b
On the power supply
The power supply of the dLAN TV Sat Tuner has three cables and a button:
b
b
b
b
Note that the power supply of the dLAN TV Sat Tuner switches to Standby after
approx. 20 minutes if the network cable is not connected to the tuner. In
Standby mode, the power supply cannot be accessed via the power grid. As soon
as the tuner is connected to the network and power cables, the power supply is
once again accessible via the power grid.
3.4
Connecting the adapter
Follow the sequence below in order to connect the dLAN TV Sat Tuner to the
LAN, the satellite antenna and the power grid.
Tip: First, check whether you can receive stations with the current alignment of
the satellite antenna, for example by connecting a receiver with a television for
test purposes. Then, check whether a connection is possible from your computer
to the dLAN TV Sat Tuner, for example by first installing the devolo software on
the computer, creating the local network on the computer and then checking
whether the Connect light is illuminated on the dLAN TV Sat Tuner when you
start the corresponding TV and radio software.
|
devolo dLAN TV Sat PC
The power jack (DC IN 12V 1.5A) is used to connect the adapter to your
power grid.
The device is connected to the network via the LAN jack.
Using the antenna input (Antenna), you can connect the dLAN TV Sat
Tuner to the LNB of the satellite antenna or the multiswitch.
Connect the power supply to the power outlet using the power cable (230V
European plug).
Connect the power supply to the power jack of the tuner outlet using the
power cable (12V DC connector).
Using the Ethernet cable (RJ45), connect the power supply to the LAN jack
of the tuner.
Using the encryption button next to the power cable, you can secure the
transmission of data via the dLAN at the touch of a button.
|
Advertisement
Table of Contents
