Scan; Starting Or Stopping A Scan Operation; Talkback; Deleting A Nuisance Channel - Motorola P040 User Manual

SCAN

You can monitor several channels in order to
receive any call that is transmitted on any of these
channels.
Once the radio's scan operation is activated and the
radio detects a call coming through a channel in its
scan list, it switches to that channel for you to
receive the call.
STARTING OR STOPPING A SCAN
OPERATION
To start or stop a scan operation:
1. Press the Scan button (only available if
programmed by your dealer) to start a scan
operation. You will hear a positive indicator
tone.
2. Press the preprogrammed Scan button again
to stop the scan operation. You will hear a
negative indicator tone.
NOTE: The LED indicator will blink (green) during a
scan operation.

TALKBACK

If the programmable Talkback option is set, you can
respond to any calls received during the scan
operation by pressing the PTT before the
programmed hang-time ends. Check with your
dealer for details.

DELETING A NUISANCE CHANNEL

If a channel continually generates unwanted calls or
noise (a "nuisance" Channel), you can temporarily
remove it from the scan list by performing a
Nuisance Channel Delete operation.
1. While the radio is on the Nuisance Channel,
press the Nuisance Channel Delete button
(only available if programmed by your dealer)
until you hear a tone.
2. Release the Nuisance Channel Delete
button. The nuisance channel is deleted.
NOTE: You cannot perform a Nuisance Channel
Delete on a priority channel or if there is only
one remaining channel in the scan list.
English
15