Table of Contents
Advertisement
Connections
Things to Know Before
Connecting Components
Protect Your Components from
Power Surges
•
Connect all components before plugging any power
cords into the wall outlet.
•
Always turn off the TV and other components before
you connect or disconnect any cables.
Position Cables Correctly to Avoid
Audio Hum or Interference
•
Insert all cable plugs firmly into their jacks.
•
Place the audio/video cables to the sides of the back
panel of the TV instead of straight down the middle
after you connect your components.
•
Try not to coil any twin-lead cables and keep them away
from the audio/video cables as much as possible.
•
Make sure all antennas and cables are properly
grounded. Refer to the Safety Tips sheet packed with
your unit.
Protect Your Components from
Overheating
•
Do not block ventilation holes in any of the components.
Arrange the components so that air can circulate freely.
•
Do not stack components.
•
Allow adequate ventilation when placing your
components in a stand.
•
Place an amplifier or satellite receiver on the top shelf of
the stand so heated air rising from it will not flow
around other components.
1
First things first
2
Setting Up the VCR
3
VCR Basics
4
Recording
5
Program The Remote
6
OTHER FEATURES
7
Connections
8
References
Things to Know Before
Connecting Components
45
Advertisement
Table of Contents
