Toshiba E-Studio 205L Quick Start Manual page 26

Chapter 1 PREPARATIONS
Saving energy when not in use – energy saving modes -
This equipment supports three energy saving modes; the Automatic Energy Save mode, Sleep mode and Super Sleep
mode. The table below shows the procedures to switch modes manually and the conditions under which the equipment
enters into or recovers from each mode.
Energy saving
modes
Automatic Energy
Save mode
Sleep mode
Super Sleep mode
*1 The default value set at the factory shipment is 1 minute.
*2 Any of the Wireless LAN Module, Bluetooth Module, Data overwrite enabler and e-BRIDGE ID Gate.
Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled, the equipment enters into the Sleep mode. Refer to the TopAccess
*3
Guide for details.
*4 Any of the [START], [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and [FAX] buttons.
*5 Even if you press the [Power] button, the equipment may not enter into the Super Sleep mode and the power may be turned OFF, depending on the
state of the equipment. Refer to the TopAccess Guide for the conditions under which the equipment enters into the Super Sleep mode.
*6 [ENERGY SAVER] button on the control panel shown below.
Refer to the MFP Management Guide for changing the default settings noted above.
For the European version
Contact your service representative to change the default settings noted above.
When the set period of time for switching to the Automatic Energy Save mode is the same as that for the Sleep mode or
the Super Sleep mode, the equipment enters into the Sleep mode or the Super Sleep mode after the set period of time.
2
Procedure to switch Conditions to enter into
modes
When a specified period of
time has passed since
*
the last use of the
equipment.
When the [ENERGY SAVER] When a particular option
button is pressed or is installed or when a
*6
when a specified period of particular protocol
time has passed since the enabled.
*
last use of the equipment.
When the [ENERGY SAVER] When a particular option
button or the [POWER] is not installed and also
*6
button is pressed or when a particular protocol
*5
when a specified period of
*3
time has passed since the
*
last use of the equipment.
Status of equipment
the mode
"Saving energy - press
START button" appears on
–
the touch panel.
"Saving energy – press
*2
START button" goes off
*3 is and the [ENERGY SAVER]
button lights in green.
Only the MAIN POWER
*2
lamp lights.
is disabled.
Conditions to recover
from the mode
When a button on the
control panel is pressed
*
or when print data or fax
data are received.
Same as the Automatic
Energy Save mode.
When the [POWER] button
is pressed and held until
the ON/OFF lamp lights,
when print data or fax
data are received through
a wired LAN or when the
time set for Scheduled
Print has come.