Installing The Receiver Battery In The Battery Box; Spektrum Dx2E Radio System; Installing The Transmitter Batteries - Team Losi LST XXL2 Instruction Manual

1/8-scale high-performance 4wd gas monster truck
Table of Contents

Advertisement

Charging the Receiver Battery Pack
Dynamite 7.4V 2000mAh Li-Po receiver pack.
The Dynamite 2S Li-Po battery pack features a balancing lead that allows you
to safely charge your battery pack when used with a Li-Po balancing charger.
1.
Remove the LiPo receiver battery pack from the battery box and disconnect the
red JST connector.
2.
Connect the LiPo battery charger to an AC power outlet.
3.
Refer to manufacturers battery charging directions.

Installing the Receiver Battery in the Battery Box

1.
Connect the fully charged LiPo battery pack to the red JST connector
in the battery box.
2.
Place the battery box cover on the battery box.

Spektrum DX2E Radio System

6
5
4
7
9
4
3
8
1
2
10
11
For more information on the transmitter, go to www.spektrumrc.com and click on the support tab
to find the full manual for the DX2E transmitter.
1.
Steering Wheel controls direction (left/right) of the model.
2.
Throttle Trigger controls speed.
3.
Antenna transmits the signal to the model.
4.
ON/OFF Switch turns the power ON/OFF for the transmitter.
5.
Indicator Lights
• Solid green light indicates adequate battery power.
• Flashing green light indicates the battery voltage is critically low. Replace batteries.
6.
ST. Trim adjusts the "hands off" direction of the model.
7.
TH. Trim adjusts the engine speed to idle at neutral.
8.
ST. Rate Adjusts the AVC sensitivity.
9.
BIND/R.O.S.S. button puts the transmitter into Bind Mode and starts or stops the engine
using R.O.S.S. (the LST XXL 2 does NOT use ROSS)
10. ST. REV reverses the function of the steering when the wheel is turned left or right.
11. TH. REV reverses the throttle control when pulled back or pushed forward.

Installing the Transmitter Batteries

1.
Push in the battery cover a small amount
to release the retaining tab, then remove
the cover.
2.
Install 4 AA batteries, taking care to align
battery polarity to the diagram in the
transmitter's battery case.
3.
Carefully reinstall the battery cover by
aligning the tabs with the slots on the
transmitter.
CAUTION: NEVER remove the transmitter batteries while the vehicle is powered on, as
loss of control, property damage or injury may result.
EN
LOSI LST XXL 2 • INSTRUCTION MANUAL

Advertisement

Table of Contents
loading

Table of Contents