Contents; Charging Warnings; Charging The Battery; Installing The Battery And Powering On The Vehicle - Team Losi MINI-T 2.0 RTR Instruction Manual

CONTENTS

CHARGING WARNINGS

CAUTION: All instructions and warnings must be followed exactly. Mishandling
of Li-Po batteries can result in a fire, personal injury and/or property damage.
• NEVER LEAVE CHARGING BATTERIES UNATTENDED.
• NEVER CHARGE BATTERIES OVERNIGHT.
• By handling, charging or using the included Li-Po battery, you assume all risks associated
with lithium batteries.
• If at any time the battery begins to balloon or swell, discontinue use immediately. If
charging or discharging, discontinue and disconnect. Continuing to use, charge or
discharge a battery that is ballooning or swelling can result in fire.
• Always store the battery at room temperature in a dry area for best results.
• Always transport or temporarily store the battery in a temperature range of 40–120º F
(5–49° C).
• Do not store battery or model in a car or direct sunlight. If stored in a hot car, the
battery can be damaged or even catch fire.

CHARGING THE BATTERY

NOTICE: Charge only batteries that are cool to the touch and are not damaged. Inspect
the battery to make sure it is not damaged e.g., swollen, bent, broken or punctured.
CAUTION: Only use chargers specifically designed to charge the included Li-Po
battery. Failure to do so could result in fire, causing injury or property damage.
CAUTION: Never exceed the recommended charge rate.
Use only the included USB charger to charge the battery.
1. Connect the charger to a suitable USB power port. The charger will work with most 5V
mobile power sources or smartphone chargers with at least 1 amp of power output.
NOTICE: Charging the battery with a USB power port with less than 1 amp of power
output can produce heat.
2. Connect the charge lead to the battery, noting correct polarity. Charging a fully dis-
charged battery takes approximately 45–60 minutes. Charge times may vary depending
on the power source.

INSTALLING THE BATTERY AND POWERING ON THE VEHICLE

1. Remove the body clips and lift the body.
2. Remove the body clips from the battery strap posts and lift the battery strap.
3. Install the fully charged battery in vehicle.
4. Re-secure the battery strap and body clips.
5. Ensure the 2-in-1 Motor/ESC is powered off.
6. Connect the battery to the 2-in-1 Motor/ESC.
7. Power on the transmitter.
8. Power on the 2-in-1 Motor/ESC.
9. Reinstall the body and the body clips.
LOSI MINI-T 2.0 BRUSHLESS RTR • INSTRUCTION MANUAL LOSI MINI-T 2.0 BRUSHLESS RTR • INSTRUCTION MANUAL LOSI MINI-T 2.0 RTR 40TH ANNIVERSARY LIMITED EDITION • INSTRUCTION MANUAL
• Always charge batteries away from flammable materials.
• Always inspect the battery before charging.
• Always disconnect the battery after charging, and let the charger cool between charges.
• Always constantly monitor the temperature of the battery pack while charging.
• ONLY USE A CHARGER SPECIFICALLY DESIGNED TO CHARGE LI-PO BATTERIES. Failure
to charge the battery with a compatible charger may cause a fire resulting in personal
injury and/or property damage.
• Never discharge Li-Po cells to below 3V under load.
• Never cover warning labels with hook and loop strips.
• Never charge batteries outside recommended levels.
• Never charge damaged batteries.
• Never attempt to dismantle or alter the charger.
• Never allow minors to charge battery packs.
• Never charge batteries in extremely hot or cold places (recommended between 40–120°
F or [5–49° C]) or place in direct sunlight.
3. Remove the battery from the charger when the charging cycle is complete.
4. Remove the charger from the power supply.
CAUTION: Once charging is complete, immediately remove the battery.
Never leave a battery connected to the charger.
Charger LED Indications
RED, solid = Charging
RED, solid; GREEN, flashing = Stand by
GREEN, solid = Charging complete
EN EN
3 3 3