Table of Contents
Advertisement
User Manual
7.3: CONTROL CHANNEL
DSP ELEMENTS > CONTROL CHANNEL
Gate Closed (X)
Indicates the selected channel's gate is closed.
Gain Reduction Meter
Indicates gain reduction for the selected channel.
These are the three LEDs on the left side labelled 1, 5, 10 (dB of attentuation).
Level Meter
Indicates audio level for the selected channel - dBfs
ON
ON key function is dependant on the channel type and selected fader layer. Momentary / Latch-
ing behaviour available from software version 1.6 (see below).
Audio channel/ bus master: Turns channel on (Green) or off (Unlit). When the channel is muted by a Mute group,
the ON button will be red.
Follow Mode (tOTEM/FADER FOLLOW button selected): Switches the send from that channel to the selected bus
on or off.
GEQ Mode (GEQ HI or GEQ LO FADERS button selected): Resets the GEQ band to 0dB. ON button will be red
when a GEQ band is 'active' (non-zero).
In Audio Channel and Fader Follow modes, holding an INACTIVE On button down will make the switch 'momen-
tary' (it will turn off again when you release it). This facilitates talkback (input channel) and audition bus (MIX/
MTX) functionality.
SEL
Select this Control Channel.
In normal operation this selects the channel or mix master channel, switching the ACS to that channel and focus-
sing the Touch Screen onto that channel. In other modes, the SEL keys are used to select channels for inclusion or
functionality, such as Mute Group setup or during an Interrogate operation.
7.3: DSP ELEMENTS > CONTROL CHANNEL
Advertisement
Table of Contents
