Brother MFC-250C User Manual page 102

Error Message Cause
The indicated ink cartridge is
Ink Low Black
running out of ink. If a sending
Ink Low Yellow
machine has a color fax to send,
Ink Low Cyan your machine's 'handshake' will ask
that the fax is sent as black & white.
Ink Low Magenta
If the sending machine has the
ability to convert it, the color fax will
be printed at your machine as a
black & white fax.
Low Temperature The print head is too cold.
The memory card is either
Media Error
corrupted, incorrectly formatted, or
there is a problem with the memory
card.
The memory card or USB flash
Media is Full.
memory drive you are using already
contains 999 files.
There is no incoming call history.
No Caller ID
You have not received any calls,
you have not activated the Caller ID
feature on your machine, or you
have not subscribed to the Caller ID
service from your telephone
company.
An ink cartridge is not installed
No Cartridge
correctly.
The memory card or USB Flash
No File
memory drive in the media drive
does not contain a .JPG file.
The machine is out of paper or
No Paper Fed
paper is not properly loaded in the
paper tray.
No Response/Busy The number you dialled does not
answer or is busy.
You tried to access a Speed Dial
Not Registered
number that is not programmed.
94
Action
Order a new ink cartridge. You can continue
printing until the LCD shows Cannot Print.
(See Replacing the ink cartridges on page 100.)
Allow the machine to warm up.
Put the card firmly into the slot again to make
sure it is in the correct position. If the error
remains, check the media drive (slot) of the
machine by putting in another memory card that
you know is working.
Your machine can only save to your memory
card or USB flash memory drive if it contains less
than 999 files. Try deleting unused files to free
some space and try again.
If you want to use the Caller ID feature call your
telephone company. (See Caller ID (Caller
IDentification) (not available in certain area)
on page 39.)
Take out the new ink cartridge and re-install it
slowly until it clicks. (See Replacing the ink
cartridges on page 100.)
Put the correct memory card or USB Flash
memory drive into the slot again.
Do one of the following:
Refill the paper in the paper tray, and then
press Mono Start or Color Start.
Remove the paper and load it again and then
press Mono Start or Color Start (See
Loading paper and other print media
on page 8.)
Verify the number and try again.
Set up the Speed Dial number. (See Storing
Speed Dial numbers on page 45.)