Installing Ktd-125 Units; Mounting The Unit - GE Interlogix KTD-125 User Manual

Installing KTD-125 Units

3 I
NSTALLING
CAUTION:
Complete all instruction steps before supplying power to the unit.
3.1 M
OUNTING THE
To mount the unit see Figure 5, Figure 6, and Figure 7 and perform the
following.
1)
Disconnect the power cable connector from the power input on the
main relay board.
Note: In most cases, it is easier to mount the unit with the main relay board
removed.
2)
Remove the main relay board from the housing.
Figure 5. Removing the finger nuts (KTD-125P-24 shown)
8
KTD-125/127 PTZ Receivers User Manual
KTD-125 U
U
NIT
Main relay Power cable
board
NITS
Finger
connector nuts
1040823A / June 2003