GE Interlogix KTD-125 User Manual page 12

Installing KTD-125 Units
Receiver
card
Figure 10.
To prepare the cables for connection perform the following.
1)
Route the cables into the housing.
2)
Remove 6 inches of the outer casing of the camera/lens, pan/tilt,
and power cables.
3)
Tie a knot in the RS422 cable(s) six inches from the end on the
inside of the housing to act as a strain relief.
4)
Remove the outer casing from the end of the RS422 cable(s).
To make the cable connections perform the following.
CAUTION:
For the KTD-125-24 and KTD-125P-24 units, connect only
110 VAC input to the power cable pigtail.
12
RS422 RS422
control in control out
KTD-125-24/125P-24 cable routing
KTD-125/127 PTZ Receivers User Manual
Watertight cable openings
Camera power/zoom lens
Pan/tilt
Removable terminal strips
24 VAC power connector
To power transformer
110 VAC power pigtail
Wire nut connections to the
110 VAC power pigtail
110 VAC power in
1040823A / June 2003