Table of Contents
Advertisement
Programming
7
P
ROGRAMMING THE
The KTD-125 and KTD-127 PTZ receivers have several mode-of-
operation choices that you must program before you operate the units.
Typically, you would program the receiver with a Kalatel controller
keypad.
To program the units manually using the DIP switches on the receiver
card, perform the following.
Site select
Figure 35. KTD-125, KTD-127, and KTD-127W DIP Switches
1)
Disconnect power from the receiver.
2)
Set DIP switch 10 to ON to put the receiver in programming mode.
3)
Set the DIP switches for the desired mode of operation as shown in
Table 3.
30
KTD-125/127 PTZ Receivers User Manual
U
NITS
Programming
Termination
1040823A / June 2003
Advertisement
Table of Contents
