Aking Able Onnections - GE Interlogix KTD-125 User Manual

Installing the KTD-127
4.2 M
AKING
See Figure 21 for the following procedures.
Figure 21. KTD-127 cable connections
To prepare the cables for connection perform the following.
1)
Route the cables into the housing.
2)
Remove 6 inches of the outer casing from the camera/lens, pan/tilt,
and 24 VAC power cables.
3)
Remove the outer casing from the end of the RS422 cable(s).
To make the cable connections perform the following.
1)
Remove the terminal strip from the main relay board.
2)
Make connections as shown in Figure 22 through Figure 24.
20
C C
ABLE ONNECTIONS
KTD-125/127 PTZ Receivers User Manual
Removable terminal strip
Receiver card
Camera power/zoom lens
Pan/tilt
24 VAC power
RS422 control out
RS422 control out
1040823A / June 2003