Panasonic UF-7100 Operating Instructions Manual page 33

ATTENTION
Correct
Incorrect
NOTE: When the optional Tray-2 is installed and the same size of paper is loaded in both trays, the paper will be
supplied from Paper Tray-2 first. This is the default setting, if you wish to change the setting, please consult with
your Authorized Panasonic dealer.
To make copies from the Sheet Bypass
1. Set the original(s) on the ADF.
2. Press .
COPY
3. Set a sheet of paper into the Sheet Bypass.
4. "✽" appears in the upper line of the LCD display.
5. If you wish to make multiple copies from the Sheet Bypass (Thick media), input the desired number of copies first,
then insert the first and press
message will appear on LCD display, insert an additional media into the Sheet Bypass (one-at-the-time) until your
copy job is completed.
Adding Paper / Tray-2
Always remove all paper from Tray-2, fan and straighten remaining paper before replenishing paper. This helps prevent
multiple sheets of paper from feeding through the Tray-2 at one time, thus reducing paper jams.
Maximum Copies Limitation
After setting the maximum allowed number of copies for each department (See page 115), consult with your Key Operator
when the total copy count reaches the designated limit and the "DEPT. MAXIMUM COPIES HAS BEEN REACHED"
message appears on the LCD.
(Side View)
When the optional Paper Tray-2 is installed, and either Paper
Tray (Tray-1 or Tray-2) is not closed firmly, paper jam may
occur.
. After each media sheet is processed, a "BYPASS ADD PAPER" prompt
START
33