Dbs Receiver Multi-Brand Remote Control - JVC HM-HDS1U Instructions Manual

84
EN
TV
1
2
NUMBER
1
2
OK
TV CH –
TV/VCR
1 2 3
4 5 6
3
7 8 9
4
0
<
>
ENTER/OK
TV CH +
– +
SPECIAL FEATURES (cont.)
DBS Receiver Multi-Brand
Remote Control
The recorder´s remote control can control functions on the
brands of DBS (Direct Broadcast Satellite) receivers listed
below.
TURN ON THE DBS
RECEIVER
1
Turn the power on using the DBS receiver's remote
control.
SET REMOTE CONTROL
MODE
2
Press TV on the remote control when "CABLE DBS"
appears on the display window of the recorder's remote
control.
ENTER DBS RECEIVER BRAND
3
Enter your cable box brand code using the NUMBER
keys, then press OK.
Follow the example shown at bottom left.
Once you have set the remote control to operate the
DBS receiver, you don´t have to repeat this step until
you replace the remote control´s batteries.
OPERATE DBS RECEIVER
4
First, press POWER to see if the DBS receiver's power
goes off as it should. If it does, try other functions (TV
CH +/– and the NUMBER keys can be used to operate
the DBS receiver).
For some brands of DBS receiver, you must press
ENTER after having pressed the NUMBER keys.
To return the remote to the recorder control, press
HDD or VHS (or S-VHS).
NOTES:
You must set the DBS receiver brand for your remote control
and the DBS receiver brand for your Controller (
separately.
Depending on the type of DBS receiver, there may be cases
where some or all functions cannot be operated using the
remote control.
It's not possible to operate a DBS receiver that is not
equipped with a remote control sensor.
Though ECHOSTAR has a number of different remote codes,
this remote control is applicable only to one of those codes
preset at the factory.
It's not possible to set the remote control for both your DBS
receiver and a cable box at the same time. You can only set
the remote control to operate one of these units at a time.
DBS BRAND NAME
JVC (DISH Network)
ECHOSTAR (DISH Network)
PRIMESTAR
SONY (DSS)
RCA (DSS)
pg. 19)
BRAND CODE
51
51
50
41
40