Advertisement
5. Gyro Sensor Zero Offset Adjustment
Preparation:
POWER switch: ON
Note:
Do not vibrate after turning on the camera.
Adjustment method:
1. Double-click on the DscCalDi.exe.
2. Select "EIS Adj" on the LCD "Test".
3. After the adjustment is completed, the adjustment value
will appear.
Carry out the adjustment again if NG will display.
FORMAT THE INTERNAL MEMORY?
3-8. Factory Code Setting
1. Check the "Factory Code" display within the Setting group.
2. For U.S.A., Canada and NTSC general area
If "FC_SANYO_U" does not appear, click on the "
located on the right of the "Factory Code" display BOX and
select "FC_SANYO_U".
3. For Europe and PAL general area
If "FC_SANYO_EX" does not appear, click on the "
located on the right of the "Factory Code" display BOX and
select "FC_SANYO_EX".
3-9. Language Setting
1. Click on the "
"Language" display BOX.
2. Select language. (Default is English.)
3. End "DscCal" and remove the camera before turning the
camera power OFF.
Calibration
Upload
AWB
Focus
UV Matrix
Cal Mode
OK
Cal Data
LCD Type
OK
USB storage
Get
VID
PID
Set
Backrush pulse :
3-10. Format the internal memory
Carry out format the internal memory after replac-
ing CP1 board.
1. Turn on the camera without inserting the SD card.
2. If the right image will appear, select "YES", and press the
SET button.
YES
NO
– 20 –
" mark located on the right of the
LCD
R Bright
B Bright
Firmware
RGB Offset
Gain
Data
Tint
Phase
PAF Cal.
EVF
VCO
H AFC
Test
Set
Serial
Set
Rev.
Get
" mark
" mark
VCOMDC
VCOMPP
Hall Cal.
Setting
Language
Set
Video Mode
Set
Factory Code
Set
Advertisement
