Connecting The Fm And Am (Mw) Antennas - JVC TH-V70R Instructions Manual

Getting Started

Connecting the FM and AM (MW) antennas

• Make sure the antenna conductors do not touch any other terminals, connecting cords, and power cords. This could cause
poor reception.
7 AM (MW) loop antenna
Setting up AM (MW) loop antenna
Attach the AM (MW) loop to its base by snapping the tabs on the loop
into the slot in the base.
If the antenna cord is covered with vinyl, remove the
vinyl by twisting it as shown.
Outdoor single vinyl-covered wire (not supplied)
If reception is poor:
Connect an outdoor single vinyl-
covered wire to the AM EXT
terminal with keeping the AM
(MW) loop antenna connected.
Center unit
7 FM antenna
Connecting the supplied FM antenna
If reception is poor:
Connect an outdoor FM antenna
with the standard type (coaxial)
connecter.
NOTES:
• Disconnect the supplied FM Antenna before attaching a 75
• We recommend that you use a coaxial cable to the FM antenna, since it is well-shielded against interference.
11
AM (MW) loop
antenna
Wire
AUX IN
TO SP-PWV70 DIGITAL IN
AV
COMPU
LINK
OPTICAL
R L
AM
LOOP
FM 75
AV
ANTENNA
COAXIAL
AM EXT
H V
RGB Y / C
DISP.SET
Outdoor FM antenna cord (not supplied)
coaxial connector (the kind with a round wire going to an outdoor antenna).
Connecting AM (MW) loop antenna
1
2
3
VIDEO OUT
VIDEO
AV OUT
S-VIDEO
Extend the supplied FM antenna horizontally.
Press and hold the
terminal clamp.
Insert the antenna cord.
Release the finger from
the clamp.
• Turn the loop until you
have the best
reception.
AC IN
Outdoor FM antenna
(not supplied)