Tuner Operations; Manual Tuning; Preset Tuning - JVC SP-PWC3 Instructions Manual

Tuner operations

IMPORTANT
Before using the remote control for the
following operation;
1 Set the remote control mode selector to
AUDIO.
2 Press FM/AM.
NOTE
• When FM or AM is selected as the source, you can select All Channel
Stereo (ALL ST) and SURR OFF mode.
The buttons described below are used on pages 35 to 38.
FM/AM
TUNING
MEMORY
TA/NEWS/INFO

Manual tuning

1
Press FM/AM repeatedly to select the
band.
Example:
When the system is tuned in to 810 kHz.
AM
2
Press TUNING 9/( repeatedly until
you find the frequency you want.
When you hold down the button until the system starts
searching for stations and then release it, the system stops
searching automatically when a station of sufficient signal
strength is tuned in to.
NOTE
• When an FM stereo program is received, the ST indicator lights on the
display window.
35
AUDIO
Remote control
mode selector
TUNING
FM MODE
/
Number buttons
PTY SEARCH
PTY SEARCH
8 1 0
kHz

Preset tuning

Once a station is assigned to a channel number, the station can be
quickly tuned in. You can preset 30 FM and 15 AM stations.
7 To preset the stations
1
Tune in the station you want to preset.
• If you want to store the FM reception mode for an FM
station, select the reception mode you want. See "Selecting
the FM reception mode" (A pg. 36).
Example:
When the system is tuned in to 103.5 MHz.
FM
2
Press MEMORY.
_ _
FM
CH
While "CH" and "– –" are flashing:
3
Press number button(s) (1-10, +10) to
select a preset number you want.
• For details on using the number buttons, see "How to use the
number buttons" (A pg. 19).
Example:
When the preset channel 1 is selected.
FM 1
CH
If the setting is cancelled before you finish, start from step 2
again.
While the selected number is flashing:
4
Press MEMORY.
The selected number stops flashing.
The station is assigned to the selected preset number.
If the setting is cancelled before you finish, start from step 2
again.
5
Repeat steps 1 to 4.
• Storing a new station to a used number erases the previously
stored one.
7 To tune in to a preset station
1
Press FM/AM repeatedly to select FM or
AM.
2
Press number button(s) (1-10, +10) to
select a preset number.
• For details on using the number buttons, see "How to use the
number buttons" (A pg. 19).
NOTE
• You can also select a preset number by pressing y/1.
1 0 3 . 5 0
MHz
1 0 3 . 5 0
MHz
1 0 3 . 5 0
MHz