Exmark Metro Operator's Manual page 23

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
4.1.5
4.1.6
4.1.7
4.1.8
4.1.9
NEUTRAL LOCK/PARK BRAKE LATCH
PTO Engagement Lever:
Located on the left side of the upper handle.
To engage the blades, push the lever forward, or away from the operator, until the
turnbuckle locks over-center.
To disengage the blades, pull the lever to the rear, or towards the operator.
Throttle-Choke-Kill Control (Kohler engines):
The throttle-choke-kill control lever is located on the control console right side.
Choke aids in starting a cold engine. The choke control is a part of the throttle
control and activates by moving the throttle control lever to the full forward
position. You will notice a detent at the "full throttle" position (approximately 3/4"
(2 cm) from top of slot) continue pushing forward into the "choke" position.
Once the engine has started, move the throttle control lever to the midway point
and allow the engine to warm-up before going to full throttle.
All Kohler engines are equipped with "throttle kill" as a standard feature. Moving
the throttle control lever to the full rear position will kill the engine. You will notice
the control lever will fall into a detent at the idle position, continuing rearward past
this detent will shut off the engine.
Throttle Control (Kawasaki engines): The throttle control is located on the control
console right side. The throttle is used to control engine speed. Moving the
throttle control forward will increase engine speed and moving it to the rear will
decrease engine speed.
Choke Control (Kawasaki engines):
Choke aids in starting a cold engine.
The choke control is located on the front left corner of the fuel tank support and
is activated by pulling the control outward.
Once the engine has started, move the choke control to the off position and
move the throttle to the medium or full throttle position. DO NOT run the engine
wit the choke in the "ON" position.
"Off-Run" Switch (Kawasaki engines):
Located on the console. Turn key to the "Run" position to allow the engine to be
started. Turn key to the "Off" position to shut engine off.
www.mymowerparts.com
FIGURE 14
ECS HANDLE
- 18 -