Programming Channel Memory - Toshiba 57HLX82 Service Manual

Adding channels to the TV's memory
When you press Channel 8 or 9, your TV will stop only on the
channels stored in the TV's channel memory.
Follow the steps below and on the next page to program all active
channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels (see page 31).
To program channels automatically:
1. Press MENU, and then press ; or : until the SET UP menu appears.
2. Press 8 or 9 until TV/CABLE is highlighted.
3. Press ; or : to highlight either TV or CABLE, depending on which you use.
If you use an antenna, highlight TV; if you use cable, highlight CABLE.
SET UP
LANGUAGE ENGL SH I
0 0 : 0 0
CLOCK SET
ANT 1 / 2 ANT 1
TV / CABLE TV / CABLE
CH PROGRAM
ADD / ERASE ADD
QUICK CONNECT GUIDE
4. Press 9 to select CH PROGRAM.
SET UP
LANGUAGE ENGL SH I
0 0 : 0 0
CLOCK SET
ANT 1 / 2 ANT 1
TV / CABLE CABLE
CH PROGRAM
ADD / ERASE ADD
QUICK CONNECT GUIDE
5. Press ; or : to start channel programming. The TV will automatically cycle
through all the TV or Cable channels
(depending on which you selected), and store all active channels in the
channel memory.
While the TV is cycling through the channels, the message "Programming
Now_Please Wait" appears.
6. When channel programming is complete, the message "Completed" ap-
pears.
7. Press Channel 8 or 9 to view the programmed channels.
Adding and erasing channels manually
After you have automatically programmed the active channels into the
TV's channel memory, you can manually add or erase specific
channels.
To add or erase channels:
1. Select the channel you want to add or erase. If you are adding a channel,
you must select the channel using the Channel Number buttons.
2. Press MENU, and then press ; or : until the SET UP menu appears.
3. Press 8 or 9 to highlight ADD/ERASE.
SET UP
LANGUAGE ENGL SH I
CLOCK SET 0 0 : 0 0
ANT 1 / 2 ANT 1
TV / CABLE CABLE
CH PROGRAM
ADD / ERASE ADD / ERASE
QUICK CONNECT GUIDE
4. Press ; or : to select ADD or ERASE, depending on the function you want
to perform.
5. Repeat steps 1-4 for other channels you want to add or erase.

PROGRAMMING CHANNEL MEMORY

– 10 –
Note: Note: Note: Note: Note:
To tune the TV to a channel not pro-
grammed in the channel memory, you
must use the Channel Number buttons on
the remote control.
Channel
Number
MENU
Channel
Control touchpad on TV front
MENU VOLUME CHANNEL
MENU
Channel
Channel
Number
MENU
Channel
EXIT TV/VIDEO