Programming The Channel Memory; Tv/Cable Function; Program Function - Toshiba COLOR STREAM 32A41 Owner's Manual

Programming the channel memory
The channel memory is the list of TV channels your TV stops on when you press CHANNEL i/V.
First, use the TV/CABLE and CH PROGRAM functions (below) to program all active channels in your area into the channel
memory. Then use the ADD/ERASE function (page 17) to add/erase individual channels in the memory.
MENU TV / VIDEO
T O
MENU
• /1_--
MENU
CHANNEL V/i
VOLUME CHANNEL
04 04
<-- _--v--i
• /I_ •/•
TV/CABLE function
RECALLQ MUTE(_ _R
FAV CH TV/VlDEC
r-_-i r-_ r--_l
REC TV/VCR STOP PLAY
I-in 1_3 I-in [-_
STILL SOURCE PtP
SLOW PAUSE REW
VPlP CH & LOCATE SWAP
TOSHIBA
-- Channel
Number
CHANNEL
1
Press MENU until the Setup menu is
displayed on-screen.
2
Press • or • until TV/CABLE is displayed
in purple.
POWER
3
Press • or I_ until the mode that
corresponds to your TV signal
system displays in purple.
TV: TV broadcast signals
(VHF channels 2 through 13 and
UHF channels 14 through 69)
CABLE: Cable TV signals
(Cable channels 1 through 125)
CH PROGRAM function
Use the CH PROGRAM function to
automatically add all active channels to the
channel memory.
1 Press MENU until the Setup menu is
displayed on-screen.
2 Press • or • repeatedly until "CH
PROGRAM" is displayed in purple.
3
4
5
Press • or I_ to start channel programming.
The TV automatically cycles through all the
TV or CABLE channels (depending on the
mode selected), and stores the active
channels in the channel memory.
When channel programming is done, you
will see the message, "Ch Programming
Completed."
Press CHANNEL • or • to scan through
the programmed channels.
TV/CABLE: [TV]CABLE
) /
_b_/Ei_S_ i _i_ _ _t_ _
V _i_ i i¸_ _;_ ,i__i_C_
MOVE[T A) SELECT[_
I_ I
TV [CAB LE ]
[ A
V _;i_i_ _ _©f_7i_
MOVE[T A I SELECT[4 I_]
CH PROGRAM
MOVE[T &] START[< 1_ I
CH PROGRAM
CABLE 24
!!,
CH PROGRAMMING
COMPLETED
CABLE 4
16