Table of Contents
Advertisement
8. While the optical engine is half mounted on the main body, make cable connections for two sockets on the lamp driving
board and four sockets on LCoS panel driving board.
9. Place the optical engine so that the positions of projection lens tip and main body lens hole and those of threaded holes of
optical engine and main body are mated, respectively. Then, fix it with screws.
4-pin connector
(gray, brown, gray and white)
Flat cable connector
Front side
Hole Optical
engine table
LCoS panel driving board
Back side
Screws
– 29 –
8-pin connector
(gray x 2 and white)
6-pin connector
(gray x 4 and white)
Lamp driving board
Lamp box
4-pin connector
(gray x 3 and
white)
3-pin connector
(brown and
white)
Advertisement
Table of Contents
