Appendix; Adding And Registering Handsets; Register A Handset To The Telephone Base - AT&T CL83101 User Manual

Appendix

Adding and registering handsets

Your telephone can support up to 12 cordless handsets. The handset must
be registered to the telephone
handset separately.
The handsets provided within your product box are already registered as
HANDSET 1 and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to HANDSET 12).

Register a handset to the telephone base

1. Make sure the handset is out of the telephone base or
charger and shows Put HS on BASE to register before you
begin registration.
2. Put the handset you wish to register on the telephone
base cradle.
3. Both the handset and the telephone base show
Registering... Please wait and the IN USE light on the
telephone base turns on. Then HANDSET X Registered
appears on both the handset and the telephone base
HANDSET represents the handset name,
screens ( (
X represents the handset
the telephone base beep and the IN USE light turns off.
The handset is now registered with the telephone base.
If registration fails, the system will automatically try
to register again. If registration fails after the third try,
Registration failed appears on both screens. Then the
handset shows Put HS on BASE to register and the
telephone base returns to idle mode. This may take up
to five minutes to occur. Please start again from
Step 1 above.
NOTE: You cannot register a handset if any other system
handset is in use.
base before use. You must register each
number). Both the handset and
86
Put HS on BASE
to register
Registering...
Please wait
HANDSET X
Registered