Registration Memory - Yamaha PSR-520 Product Manual

Registration Memory

3
Register the Settings .......................................
While holding the [MEMORIZE] button, press one of the REGISTRA-
TION MEMORY buttons. Any data that was previously in the selected loca-
tion is erased and replaced by the new settings. The corresponding Registra-
tion Memory number will appear above "REGIST" in the display.
•
Enter a New Name for the Registration Bank
If you want to enter a descriptive name for easier identification, enter
your original Registration Bank name, this is recommended.
Use the cursor
character of the Registration Bank name in the display. A Registration
Bank name can consist of up to 8 characters. The position of the charac-
ter you want to enter or change can be selected by moving the cursor.
Using the [-/NO] and [+/YES] buttons or the data dial, enter the de-
sired character listed below. The number buttons can also be used to en-
ter the number. If you want to insert an underline character at the cursor
position, press the cursor [
the cursor position, press the cursor [
entering the Registration Bank name, move the cursor to the position
other than the Registration Bank name so that the newly entered Regis-
tration Bank name will be memorized.
Character List
button to move the cursor to the first (left most)
] button. If you want to delete a character at
ù
] button; When you've finished
ü
note that anytime you
Please
store to a REGISTRATION
MEMORY button, all settings
previously stored in that button
will be erased and replaced by
the new settings.
The Registration Memory data
including it's name is retained in
memory even when the power
switch is turned OFF, as long as
the batteries are installed or the
AC adaptor is connected.