Yamaha PSR-520 Product Manual page 60

The Multi Pads
3
Select a Voice and Other Parameters ..........................................
Select a voice and related parameters you want to record on the MULTI
PADS. You might also want to set a tempo that will be easy to record at.
If you select a pitched voice to record, the data will automatically be
transposed to match the chords played by the Auto Accompaniment feature
("chord match").
4
Engage the MULTI PAD Record Ready Mode................
Press one of the MULTI PAD buttons - [1] through [4] - while holding
the [REC/END] button. The [REC/END] indicator will flash to indicate
that the record ready mode is engaged.
The four dots of the BEAT display flash at the current tempo. If the
"Metronom" function in the OVERALL function group is turned ON, the
metronome will begin to sound at the currently selected tempo.
5
Record .................................................................
Play a short sequence. The [REC/END] indicator will light during re-
cording, and the BEAT indicator dots will indicate the current beat.
If you want to play back the recorded data as the "chord match" type,
record all the phrases on CM7. The sound will be properly transposed when
used with the Auto Accompaniment feature.
6
Stop Recording .............................................
Stop recording by pressing the [REC/END] button. The [REC/END]
button indicator will go out.
You cannot record in the SPLIT/
SINGLE/FINGERED mode - the
NORMAL mode will automatically
be selected when the MULTI
PAD record ready mode is en-
gaged.
If a non-user multi pad kit number
is selected when the record
ready mode is engaged, user
multi pad kit number 22 will
automatically be selected.
The recorded multi pad volume
depends on the current Keyboard
Volume setting — see page 67.
[DSP] button is disabled when
the MULTI PAD is in record
ready mode and record mode.
Also, DSP will automatically be
turned OFF when the MULTI
PAD record ready mode is en-
gaged.
Whenever you record to a MULTI
PAD, all previous data in the
same pad will be completely
erased and replaced by the new
material.
If the MULTI PAD memory be-
comes full while recording, "Full"
will appear on the display and
recording wilI stop.