Maintenance - Makita 6796D Instruction Manual

MAINTENANCE

1. Limit mark
1. Brush holder cap
2. Screwdriver
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
• Screw bits
• Adjusting grip
• Protector (red, blue, yellow)
8
NOTE:
• The revolution angle means the angle which a screw/bolt revolves when
the tool attains to 100% from 50% of desired torque.
CAUTION:
• Always be sure that the tool is switched off and the battery cartridge is
removed before attempting to perform inspection or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
002684
brushes, insert the new ones and secure the brush holder caps.
1
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
2
• Grip base set and Grip 37
• Various type of Makita genuine batteries and
chargers