Operation - Makita 6796D Instruction Manual

ASSEMBLY
1
1. Bit
2. Sleeve

OPERATION

CAUTION:
• Always be sure that the tool is switched off and the battery cartridge is
removed before carrying out any work on the tool.
Installing or removing driver bit
004334
12mm
Use only the driver bit or socket bit shown in the figure. Do not use any other
driver bit or socket bit.
9mm
To install the bit, pull the sleeve in the direction of the arrow and insert the bit
002650
into the sleeve as far as it will go. Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the arrow and pull the bit
out.
NOTE:
• If the bit is not inserted deep enough into the sleeve, the sleeve will not
return to its original position and the bit will not be secured. In this case,
2
try re-inserting the bit according to the instructions above.
Screwdriving operation
002678
Place the point of the driver bit in the screw head and apply pressure to the
tool. Then switch the tool on. When the clutch cuts in, the motor will stop auto-
matically. Then release the switch trigger.
NOTE:
• Make sure that the driver bit is inserted straight in the screw head, or the
screw and/or bit may be damaged.
Limits of fastening capacity
Use the tool within the limits of fastening capacity. If you use the tool beyond
the limits, the clutch does not work. And the tool cannot deliver enough fasten-
ing torque.
360
300
240
180
120
60
0
1
Capacity limit of 6796D/FD
360
300
240
180
120
60
0
2 3 4 5
Capacity limit of 6797D/FD
360
300
240
180
120
2 3 4 5 6 7 8
Torque N.m
004335
Capacity limit of 6798D/FD
60
0
6 7 8 9 10 11 12
7