Percent Mode; Menu Navigation - OHAUS Pioneer Instruction Manual

Pioneer
™
accuracy of the count. The balance automatically recalculates the Average Piece Weight when the number of parts
on the pan is less than three times the original sample size. The display shows [APwW.OPT] each time the APW is
optimized.

3.3 Percent Mode

To access the Percent Mode, press Unit until the display shows [PErCEnt].
Establish a new Reference Weight - With Clear reference [CLr.rEF] displayed, Press No to use the previously
saved Reference Weight. Press Yes to establish a new Reference Weight. Put the reference sample on the pan
and press Yes to accept or
Percent – Place the object(s) to be compared to the reference weight on the pan.
3.4 Weigh Below Feature
Remove Weigh Below Cover
4. SETTINGS

4.1 Menu Navigation

InCal* AZSM
SPAN FILTER
LINEAR** A.TARE
CAL ADJ GRAD
END.CAL
GBL RST
END.SET
* InCal models only
** Not available in InCal models
ENTER MENU – When the balance is on, press and hold Unit/Menu until [mMENU] appears.
Release the button and the Calibrate [.CAL.] menu will display.
MENU NAVIGATION – Select menus, menu items and settings through use of the Yes and No buttons.
Solid arrows point to the content displayed when Yes is pressed, Dashed lines when No is pressed.
CHANGING SETTINGS – To select the displayed Setting, press Yes. To move to the next Setting, press No.
EXIT MENU – When [.END.] is displayed, press Yes to exit the menu function, or press No to return to the Cal
menu. Note: Press and hold No at any time to exit quickly.
– Use this mode to measure the weight of a sample as a percentage of a reference weight.
No to abort.
Attach wire or string to Hook
COUNT
APWOPT
PERCENT
END.MOD
NO
YES
GRAM
OUT STA
MILLIGRAM A. PRINT
KILOGRAM
CONTENT
OUNCE
LINE FO
POUND END.PRT
NOT ALL
UNITS
SHOWN
END.UNIT
Suspend sample
BAUD CAL
PARITY SETUP
HAND.SH MODE
END.R232
UNIT
PRINT
RS232
END.LOCK
EN-4