BEFORE YOU OPERATE
Figure 7
Handling Engine Oil
1. When handling and storing engine oil,
be careful not to allow dust and water to
contaminate the oil. Clean around the
filler port before filling.
2. Do not mix lube oils of different types or
brands. Mixing may cause the chemical
characteristics of the oil to change and
lubricating performance to decrease,
reducing the engine's life.
3. Engine oil should be replaced at the
specified intervals, regardless if the
engine has been operated.
Engine Oil Viscosity
SAE 10W-30 or SAE 15W-40 are the
recommended oil viscosities.
If you operate your equipment at
temperatures outside the limits shown,
consult your authorized Yanmar dealer or
distributor for special lubricants or starting
aids.
40
Checking the Engine Oil
Figure 8
Note: 4JH4-TE shown. Other models
are similar.
1. Make sure the engine is level.
2. Remove dipstick (Figure 8, (3)) and
wipe with clean cloth.
3. Fully reinsert dipstick.
4. Remove dipstick. The oil level should
be between upper (Figure 8, (4)) and
lower (Figure 8, (5)) lines on the
dipstick.
5. Add oil if necessary. See Adding
Engine Oil on page 40.
6. Fully reinsert dipstick.
Adding Engine Oil
1. Remove the yellow oil filler port cap
from filler port (Figure 8, (1)) and fill
with engine oil.
Prevent dirt and debris from
contaminating engine oil. Carefully
clean the dipstick and the surrounding
area before you remove the cap.
JH Series Operation Manual
(1)
(2)
(3)
(4)
(5)
0004490