Table of Contents
Advertisement
Disassembly
Replacing the Controller Board
Removing the Volume / Smart Buttons
G
28
Figure 14. Replacing the Controller Board
1.
Insert the controller board at an angle into the front housing, taking care to
position the edge of the board under the volume / smart button. (see Figure 14).
2.
Carefully insert the flex into the ZIF connector. Ensure the flex is properly
seated in the ZIF connector.
3.
Close the ZIF connector latch (see Figure 12).
4.
Replace the board to board spacer, transceiver board, back housing, SIM card,
battery, and battery door as described in the procedures.
1.
Remove the battery door, battery, SIM card, back housing, transceiver board,
board to board spacer, and controller board as described in the procedures.
The volume button and smart button are connected together by a molded web to
form a single part .
2.
Insert the blunt end of the disassembly tool between the volume button and
the front housing and carefully pull the volume button away from the front
housing (see Figure 15A).
Use care when removing the volume/smart buttons to prevent damage to the
buttons.
A009
CONTROLLER BOARD
VOLUME / SMART
BUTTON
001152-O
6881037B20
Advertisement
Table of Contents
Troubleshooting
