Kick Plate Installation; Height-Adjustable Shelf - Haier HB21FC45N Series Service Manual

SERVICE MANUAL
Model: HB21FC45N*
8. Clean the Pipe
Power the main water supply till the water in the pipe becomes clean.
Turn off the water valve after having used water of about 1V.
9. Connect the pipe to the refrigerator.
Before connecting the pipe to the refrigerator, make sure
that the power line is not cut into the electric plug on the wall.
(1)
Tighten the water pipe on the water valve and take the nut off
the water pipe.
(2)
And then ,as shown in the figure ,connect the end side of the
water pipe to the water valve; tighter the water pipe using tightening
nuts.

3-5. Kick Plate Installation

The kick plate is packed in the fresh food compartment. Attach the panel with the screws provided.

3-6. Height-adjustable Shelf

The height of shelf can be adjusted to meet your storage needs.
To adjust the shelf height, remove the shelf first. The steps are as follows:
1.tilt the shelf up at front, and lift it up and out of tracks. 2. To replace the shelf, with shelf front raised
slightly, engage the lugs in tracks. Then lower shelf front until it locks into position.
To replace
Issue 2010-07-05
Rev. Ref1007S019V0
To remove
15