Table of Contents
Advertisement
10- Installation
10.1 Unpacking
WARNING!
▶ The appliance is heavy. Always handle with at least two persons.
▶ Keep all packaging materials out of children´s reach and dispose them in an environ-
mentally friendly manner.
▶
Take the appliance out of the packaging.
▶
Remove all packaging materials including the transparent protective film.
10.2 Environmental conditions
The room temperature should always be between 10° C and 38° C, since it can influence
the temperature inside the appliance and its energy consumption. Do not install the appli-
ance near other heat-emitting appliances (ovens, fridges) without isolation.
10.3
W
10.4
10.5
1.
max 45°
3.
28
10.3 Space requirement
Required space when door is opened (Fig. 10.3):
10 cm
Appliance width W:152 cm
Appliance depth D: 102 cm
D
10.4 Ventilaton cross-section
To achieve sufficient ventilation of the appliance for
safety reasons, the information of the required ventila-
tion cross sections must be observed (Fig. 10.4)..
50mm
10.5 Aligning the appliance
The appliance should be placed on a flat and solid sur-
face.
1. Tilt the appliance slightly backwards (Fig. 10.5).
2. Set the feet to the desired level.
Make sure the distance to the wall on the hinge
sides is at least 5 cm.
2.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slightly swaying should
be the same in both directions. Otherwise the
frame can warp; possible leaking door seals are
the result. A low tendency to the rear facilitates
the closing of the doors.
GB
Advertisement
Table of Contents
