Troubleshooting - Minolta data memory back dm9 Instruction Manual

DM9E 12/15/98 11:37 AM Page 50

TROUBLESHOOTING

indicates that the enclosed items are blinking .
• When inserting a new SmartMedia card after a CArdErr,
p ress the DATA button in the camera's data panel to make
sure the data memory function is on (p. 19).
• Data is not recorded by the DM-9 or the camera when
[CArdErr] blinks in the DM-9 data panel.
50
Card not inserted. Appears
when the shutter release or
data button are pressed (p.16).
Back is open, not mounted, or
the contacts aren't clean.
Replace the battery.
Back closed without inserting a
SmartMedia card after changing
the battery. Data number will
not be imprinted. Turn the
camera's main switch to LOCK,
insert a SmartMedia card, then
turn the main switch to ON.
Data being recorded. Do not
remove the Batteries or the
SmartMedia card or open the
back of the camera.
Card being formatted. Do not
remove the Batteries or the
SmartMedia card or open the
back of the camera.
SmartMedia card is full. Data
will be overwritten.
SmartMedia card not inserted
properly.
SmartMedia card not usable.
SmartMedia card is write
protected. Remove the write-
protect seal to read or write
data.
SmartMedia card is not
formatted properly for use in
this device. Remove and insert
a new card or reformat (p.28).
Data not successfully recorded
to the card at rewind.
To Record the Data
1. Remove the rewound film.
2. Close the back cover (do not load a new roll).
3. Format or replace the SmartMedia card.
4. Open the control panel door, then press the rewind
button.
• Data is recorded to the SmartMedia card.
• dAtA REc appears in the DM-9 data panel.
51