Table of Contents
Advertisement
Figure 1-4. IStran PCB Mounted on Base Plate (Cover removed)
1.1.1 IStran PCB
Switched Mode Switched mode sets the TX drivers into a high-impedance state to
Unswitched Mode In unswitched mode, the TX drivers are always active and they always
Issued Nov-09
ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN)
The IStran PCB provides two interfaces designated hazardous and non-
hazardous. You configure each interface independently to operate in
either switched or unswitched mode.
reduce power consumption.
follow the corresponding RX inputs. In cases where power consumption
is not a key factor, configure the IStran for unswitched mode.
Introduction
1-3
Advertisement
Table of Contents
