Download  Print this page

Handling The Discs - Sanyo CDF-M200 Instruction Manual

Car cd player with fm modulator
Hide thumbs


Extremely hot places, such as those
exposed to direct sunlight or hot air coming
directly from a heater
Damp places or those where the player
can get wet, such as places exposed to
blowing rain
Dusty locations
to get any water on the player because it
can be damaged.
properly in extreme heat or cold. In this
case, wait until the temperature in the car is
more normal, then use the player. Closed
up cars in summer get very hot. If the
temperature inside the player goes above its
reference temperature, a protective circuit
automatically stops the play and ejects the
disc. In this case, open the window to cool
off the car, then start up the player again.
During cold weather, moisture drops
sometimes form on the optical lens of the
disc player after the heater is turned on.
This is called condensation. On a rainy day
or in a very damp area, moisture may
condense on the laser lenses inside the
unit. With this condensation on the lens, the
disc player cannot read the disc and
therefore cannot function properly. The time
required depends on the surroundings, but
if you remove the disc from the player and
wait for about an hour, the condensation will
evaporate and the disc player will be able to
function properly again.
If you are driving on a rough road, sound
may Lsometimes be skipped. It is inevitable
and will not cause any damage, disc
scratches etc.
slot for compact discs. The inside of the
disc player is precision equipment that
could be damaged by any foreign objects.
forget to remove the compact disc. Do not
leave an ejected disc sitting on the edge of
the disc player for a long time. This can
expose the disc to direct sunlight and other
causes of warping. Keep the discs in their
cases away from direct sunlight.
low enough to enable you to hear outside
sound when driving.
repair it. The inside of the disc player is
precision equipment, so if there is any
problem, bring it to the store where you
purchased it for servicing.
chemical solvents as this might damage
the finish. Use a clean, dry cloth.


Dirt, dust, scratches and deformation
cause sound skips during playback and a
deterioration of sound quality.
How to take care of your discs:
shown on the right.
carefully wiped off the disc's signal surface
(glossy side) with a soft cloth. Unlike
conventional records, the compact disc
has no grooves to collect dust and
microscopic debris, so gently wiping with a
soft cloth should remove most particles.
Wipe in a straight motion from the inside to
the outside of the disc. Small dust particles
or light stains will have absolutely no effect
on reproduction quality.
sprays, antistatic sprays or fluid, benzine
or thinner to clean compact discs. Such
chemicals would irreparably damage the
disc's plastic surface.
after use to avoid serious scratches that
could cause sound skip.
high humidity, or high temperatures for
extended periods of time. Long exposure
to high temperatures can warp the disc.
a ball-point pen on the disc surface.


Table of Contents

  Also See for Sanyo CDF-M200

  Related Manuals for Sanyo CDF-M200