Table of Contents
Advertisement
Mounting Instructions and EAS Installation Guide
Option A - Resting on the Counter Top
Cut a hole in the counter 6.26 in. (159 mm) square, as shown in the
1.
illustration below.
2. Place the bucket into the hole.
3. Unscrew and remove the scanner connector cover.
4. Place the scanner on the counter near the bucket.
5. Route the cables from beneath the hole and attach to the scanner
as shown in
6. Reattach the connector cover and tighten the screws.
7. Lower the scanner into the bucket.
IMPORTANT
screws after all cables are connected to the scanner ports. The
connector cover ensures that all cables are properly situated and
connections are secure.
Counter Hole
7.91 in.
201 mm
Typical Layouts on page
Always reattach the connector cover and tighten the
6.26
6.81 in. ±0.06
159
173 mm ±1.5
~3.5 in.
89 mm
4.
7
Advertisement
Table of Contents
