How To Access Service Mode - Samsung HP-R5052 Service Manual

Alignment & Adjustment

3-2 How to Access Service Mode

■ Using the Customer Remote
1. Turn the power off and set to stand-by mode.
2. Press the remote buttons in this order; MUTE-1-8-2- POWER ON to turn the set on.
3. The set turns on and enters service mode.
4. Press the Power button to exit and store data in memory.
※ If you fail to enter service mode, repeat steps 1 and 2 above.
5. Initial SERVICE MODE DISPLAY State
HDMI/DTV HD
Calibration
Option Byte
White Balance
SVP-EX
MST9883
MSP34XX
YC Delay
DNIe Lite
T-STRANUS0S-0036 Jan 12 2005
T-STRANUS5-0117 [Sec : 29]
※ "T-STRANUS0S-0036" and "T-STRANUS5-0117" are firmware version.
The firmware version is subject to change without notice.
6. Buttons operations within Service Mode
MENU
Direction keys ▲ / ▼
Direction keys ◀ / ▶
Source
3-2
Adjust
Test Pattern
Chip Debugger
Checksum
Option PDP
RESET
Full Menu Display / Move to Parent Menu
Item Selection by Moving the Cursor
Data Increase/Decrease for the Selected Item
Cycles through the active input source that are connected to the unit
Samsung Electronics