How To Access Service Mode - Samsung HPS5033X/XAC Service Manual

Alignment & Adjustment

3-2 How to Access Service Mode

1. General Remote
To Enter : Power Off → MUTE → 1 → 8 → 2 → Power On
(Interval between key strokes : less than 3 sec)
To Exit : Power Off → On
2. Factory Remote
To Enter : Power On → INFO → FACTORY Key (Interval between key strokes : less than 3 sec)
To Exit : Power Off → On
Press the Factory key twice with a key stroke interval of more than 1 second (Pressing once enters Aging Mode)
3. Settings when entering Factory mode
- Sharp Screen (Dynamic), Color Tone (Cool1), Factory (Dynamic CE Off)
4. Adjustment Procedures
- Channel ▲ ▼ Key : Select an item.
- Volume ◀▶ Key : Adjust the value up or down.
- MENU Key : Save the changes to the EEPROM and return to the higher-level mode.
- Using the Numeric (0~9) keys, you can select a channel.
- Using the SOURCE key, you can switch AV modes.
5. Initial SERVICE MODE DISPLAY State
Calibration
Option Byte
White Balance
W/B Movie
SVP-PX
LBE
SOUND(STV825X)
Sub Micom Download
T-CADINUS0S-2001 Apr 5 2006
T-CADINUS5-0061 [Sec :20]
※ The version of the firmware displayed at the bottom of the screen may differ and the firmware is subject to change for the
improvement of product functions.
※ If you have adjusted the settings in Service Mode, you have to reset the product.
3-2
NTSC-RF
Checksum
KS1406
KS1409
Dynamic Contrast
EEPROM Access Count
PDP Option
RESET
Vol=8, B/S=On, 10W, US_Mesh
Samsung Electronics