Programming Zone Descrip-
tions
When entering zone descriptions:
• Buttons
and
the cursor within the display.
• Buttons
and
through numbers, letters, punctuation
marks and a variety of symbols.
Enter an identifying description for each
zone then press the
save button. To
advance to the next zone (or to any other
zone):
1. Move the cursor to the displayed
zone number (i.e., "01") using buttons
and
.
2. (a) Change the zone number using
buttons
and
, then (b)
move the cursor to the first character of
the description and program a description
for the new zone.
22
GEM-RP1CAE2.pub
page 22
P R O G R AM M I N G ( O P T I O N AL )
To Program Zone Descriptions
1. Set the Cursor Position using
buttons
and
.
position
2. Select characters for zone
description using buttons
and
.
scroll
3. Press the
button to save
each descriptor.
NOTE: Press
To continue press
3. Press the
save button. Advance to the next zone using buttons
and
as described above and repeat until all zones have been
programmed.
button to clear character at cursor.
or
button.
Programming Zone Descriptions
Tuesday, September 29, 1998 09:28