Handling Beovision 4 - Bang & Olufsen BeoVision 4 Manual

4
We recommend that you follow the
procedure described below when
you set up BeoVision 4:
– Unpack BeoVision 4 and place it as
described and illustrated to the
right under Handling BeoVision 4;
– Consider the appropriate
placement for BeoVision 4. Guide-
lines are included to the right
under Placing BeoVision 4 in your
home;
– Connect the cables as described in
Connect BeoVision 4 to
BeoSystem 1. For information
about how to fasten and run the
cables on the rear of BeoVision 4,
refer to the opposite page.
For an overview of the close-up
operation and socket panels, refer to
pages 7–8.
Set up your BeoVision 4

Handling BeoVision 4

Due to the weight of BeoVision 4, any moving
or lifting of the screen should be done by two
persons.
When lifting BeoVision 4, grip the top and
bottom edges of the screen.
Carry BeoVision 4 in such a way that the
screen is in an upright position at all times.
If you must put BeoVision 4 down at any time
prior to placing your screen, we recommend
that you rest it in an upright position on its
bottom edge on a stable, flat surface. Make
sure that at least one person steadies
BeoVision 4 while it rests in this fashion!
You may also place BeoVision 4 with the
screen side down on a stable, flat surface that
you have covered with cloth or other soft
material. To avoid exposing the screen itself to
pressure, rest BeoVision 4 only on surfaces
large enough to allow the weight of
BeoVision 4 to rest on the screen frame, as
opposed to the screen glass.
Regardless of whether you place BeoVision 4 on
a table stand or in a wall bracket, make sure to
leave adequate space around the screen for
ventilation purposes, as described to the right.
Placing BeoVision 4 in your home
To be able to mount BeoVision 4 in a wall
bracket or on a table stand, refer to the
instructions enclosed with the bracket or
stand. Under all circumstances, make sure
that BeoVision 4 can not be tipped over or
jostled loose from the selected bracket or
stand.
– Set up, place and connect BeoVision 4 in
accordance with this Guide.
– BeoVision 4 is developed for indoor use in dry,
domestic environments only. It is designed for
use within a temperature range of 32–105º F
(0–40º C) and a relative humidity range of
20–80%.