Adjusting The Brightness Of The Display; Using The Power Saving Function - Ricoh WG-30 Operating Manual

Adjusting the Brightness of the Display

You can adjust the brightness of the display to 7 levels.
1
Use the four-way controller (23) to select [Brightness Level]
in the [W Setting] menu.
2
Use the four-way controller (45) to adjust the brightness.
F
G
H

Using the Power Saving Function

You can save the battery power by setting the display to dim automatically when
no operation is performed for a fixed time. After the Power Saving function has
been activated, the display returns to the ordinary brightness if any button is
pressed.
1
Use the four-way controller (23) to select [Power Saving] in
the [W Setting] menu.
2
Press the four-way controller (5).
A pull-down menu appears.
3
Use the four-way controller (23) to select the time until the
camera enters Power Saving mode.
Choose from [2min.], [1min.], [30sec.], [15sec.], [5sec.] or [Off].
4
Press the 4 button.
The setting is saved.
• Power Saving does not function in the following situations:
- While taking pictures in j (Continuous Shooting) and c (Burst
Shooting) modes
- In playback mode
- During movie recording
- While the camera is connected to a computer
- When using the AC adapter
- While a menu is being displayed
- In (Digital Microscope) mode
• When no operation is performed after the camera is turned on, Power
Saving is activated only after 15 seconds elapse even if [5sec.] is set.
Dark
Normal
Bright
6
161