Volkswagen Golf Variant 2007 Workshop Manual page 117

– Remove punching burr on ring terminal using the deburrer.
– Tighten ring terminal to specified torque ⇒ Electrical system;
Rep. Gr. 27 .
Note
Optimum contact is ensured when the components to be secured
are tightened to the specified torque after cleaning.
– Apply suitable anti-corrosion treatment to connection
⇒ page 115 .
– Reconnect the battery -A- ⇒ Electrical system; Rep. Gr. 27 .
WARNING
Danger of injury! Observe warning notices and safety regula‐
tions ⇒ page 2 !
3.1.2 Repairing threaded connections
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1331-
Note
The use of penetrating fluid, contact spray or grease is pro‐
♦
hibited since the lack of adhesion in the threads may cause a
torque excess and, therefore, the breaking of the threaded
connection.
The grey sanding pads are suitable for light dirt and "soft sur‐
♦
faces". The red sanding pads are suitable for heavy dirt and
"hard surfaces".
WARNING
Danger of injury! Observe warning notices and safety regula‐
tions ⇒ page 2 !
Carry out following procedures:
– Disconnect the battery -A- ⇒ Electrical system; Rep. Gr. 27 .
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
Electrical System, General Information - Edition 05.2010
3. Contact surface cleaning set VAS 6410
113