Power Surges - Teka VTN DC Installation And Maintenance Manual

GB
1 Touch the clock sensor
times, until the pilot light (14) underne-
ath the clock indicators (8) lights up.
2 Use the
the time.
The countdown timer is activated, even
though the hob is disconnected, until it has
counted down the time required, or until
you turn it off.
Switching off the counter
If you wish to stop the countdown timer be-
fore the programmed time has elapsed:
1 Touch the clock sensor
times, until the pilot light (14) underne-
ath the clock indicators (8) is lit.
2 Use sensor
00. The clock is cancelled.
Quick switch-off
1 Touch the countdown timer sensor
(7) various times, until the pilot light (14)
underneath the clock indicators (8) is lit.
2 Touch sensors
multaneously and the counter will be
disconnected.
MODELS TC 620, TR 735 AB AND TR 641
Whenever the clock is not being used in
conjunction with a cooking area, it can be
used as a countdown timer. To do this, you
use the clock without selecting a hotplate.
Switching on the counter
When the appliance is switched off.
1 Touch the On sensor
30
(7) various
or sensors (5/4) to alter
(7) various
(4) to reduce the time to
and (5 and 4) si-
(1).
2 Before using any hotplate, touch the
clock sensor (7). All the control dis-
plays (11) are switched off.
3 Use the or
time.
When the programmed time elapses, a se-
ries of beeps will sound for several se-
conds. To switch these beeps off, touch
the sensor (7).
Switching off the counter
If you wish to stop the countdown timer be-
fore the programmed time has elapsed:
1 Select the countdown timer sensor
(7). The decimal point (13) will come on.
2 Use sensor (4) to reduce the time to
00. The clock is cancelled.
Quick switch-off
1 Select the countdown timer sensor
(7). The decimal point (13) will come on.
2 Touch the sensors
taneously and the clock will be discon-
nected.
Always keep the area for contro-
lling the cooking areas empty and dry.
When any problem concerning the
controls arises that is not covered in
this manual, you should disconnect the
appliance and contact TEKA's technical
service.

Power surges

When the touch control system undergoes
a power surge of the type which may occur
within electricity supply networks, the hot-
plates will disconnect and a continuous, in-
sensors to input the
or (7/4) simul-