Electrical Connections - Kingspan KHP0041 Installation And Maintenance Manual

Safety procedures
Units installation
The installation must be carried out by a qualified
installer.
DO NOT INSTALL IN A PLACE...

Electrical connections

All field electrical connections are the responsibility of
the installer.
DANGER
Electrical shock can cause severe personal injury
or death. These operations are to be carried out by
qualified personnel only.
!
WARNING
electromagnetic compatibility (2004/108/EC) and pressure
equipment (EEC/97/23) Directives.
are carried out by qualified personnel only.
followed for the main supply circuit.
in place.
supply are those required; the available power must
be adequate to operate any other possible appliances
connected to the same line.
in conformance with the unit power input indicated in the
rating plate of the unit.
switches are installed.
allow full disconnection under the conditions provided for
by overvoltage class III.
CAUTION
cable is connected in a wrong way, electric parts may be
damaged.
!
CHOOSE A PLACE...
weight and minimize vibration transmission.
!
Note...
If the unit is installed in areas where heavy snowfalls may
occur, it is necessary to raise its level at least 200mm above
the usual snow level or alternatively to use the outdoor
unit wall mounting bracket kit. See Kingspan optional
extras such as the "snow feet" (Anti vibration foot KHP0044 )
recommended for exposed areas to help create an air gap
under the unit.
the cable must only be replaced by the technical support
in order to prevent any risk.
firmly to the terminals.
WARNING
may cause electric shock.
lightning rods or ground wires for telephone cables.
DANGER:
Do not modify this unit by removing any of the safety
guards or by by-passing any of the safety interlock switches.
FINAL CHECK
!
WARNING
ventilate the room immediately.
source, such as a cooking range, poisonous gas is
generated.
!
Contact the manufacturer if one of the following
events takes place:
7