R-410A - General Info - Kingspan KHP0041 Installation And Maintenance Manual

Introduction
The information in this manual is to provide general
assistance in the selection of equipment. The responsibility
for the specification of the equipment must however
remain that of the installer and any consultants or
designers concerned with the installation, specification or
design.
Any water distribution and central heating installation must
comply with the relevant recommendation of the current
version of the Regulations and British Standards listed
below:
Building Regulations
I.E.E. Requirements for Electrical Installations (BS7671)
Water Regulations
Manual Handling Operations Regulations
British Standards BS6798, BS5449, BS5546, BS5440:1,
BS5440:2, CP331:3, BS6700, BS7593 and BS7671.
Health and Safety Document No 635.
When installing unvented hot water systems section G3 of
the Building Regulations should be adhered to. An annual
inspection would also be required to ensure safe, long term
operation.

R-410A - General info

(R410A) which does not destroy ozone layer.
than R-22. Be sure that servicing equipment and
replacement components are designed to operate with
R-410A.
liquid to flow out with the cylinder in a vertical position
with the valve at the top.
refrigerant. Use a commercial type metering device in the
manifold hose in order to vaporize the liquid refrigerant
before it enters in the unit.
with oils recommended by the compressor manufacturer.
CAUTION:
the heat pump open to atmosphere any longer than
minimum required for installation.
moisture absorption.
tubing is 40 mg/10m.
4
Please note: Kingspan Renewables do not accept
any responsibility for matters of specification, design
or selection or for the effectiveness of an installation
containing one of our products unless we have been
specifically requested to do so.
Important Note - Included in the Aeromax Plus
introduction pack is the Kingspan Renewables 2-year
extended warranty registration card. Please use this card
to register within 30 days of commissioning/occupation
if new build, and ensure the homeowner benefits from
the extended warrantee. This needs to be completed by
both the Approved Installer and the current homeowner
(or a signature of developer is required if new build). The
registration card is free post and is logged by our warranty
department.
In the unlikely event of failure of the Aeromax Plus heat
pump, return of the card ensures that the homeowner's
warranty claim is dealt with efficiently.
All goods are sold subject to our Conditions of Sale (see
Web site for details).
oil.
atmosphere.
vacuum.
vacuum with dry nitrogen and replace filter driers.
Use this unit only for factory approved applications.
The capacity and unit code are stated on the nameplate
data.