What Is A Programmer - Kingspan KHP0041 Installation And Maintenance Manual

7 day hot water programmer
Copy Functions Explained
AB Copy: The AB copy function is available in 5+2 mode
only and only if activated in the Advanced Programming
setting.
A and B days, when selected, can be any group of days e.g.
example, to operate in a 5+2 day mode the days can be set
as follows:
A Days
Event Programming in AB mode
1. Programme "A" day events using the + (time advance), -
(time decrease), and NEXT (next period) buttons.
2. Press the DAY button to change to programme the "B"
days
3. Programme "B" day events using the + (time advance), -
(time decrease), and NEXT (next period) buttons.
Service Interval Timer
The TS715 Si is fi tted with an installer setback service
interval timer. If this feature is required please contact
our technical department. Setting instructions for this
gas safety feature are only available to bona fi de heating
installers.

What is a programmer?

... an explanation for householders.
Programmers allow you to set 'On' and 'Off ' time periods.
Some models switch the central heating and domestic hot
water on and off at the same time, while others allow the
domestic hot water and heating to come on and go off at
diff erent times.
Set the 'On' and 'Off ' time periods to suit your own lifestyle.
On some programmers you must also set whether you
want the heating and hot water to run continuously, run
under the chosen 'On' and 'Off ' heating periods, or be
permanently off .
Please Note:
Please note: A timeswitch is a single channel programmer. It will allow you to set your system's On and Off periods.
To use the AB copy function – press the PROG button:
1. This will show the "A" days, with all the days selected.
2. Use the DAY button to highlight a day.
3. Subsequent presses of the DAY button will increment
through the days.
4. Press the + button to select a specifi c day as an "A" day,
or press the – button to specify a day as a "B" day.
5. Once the day has been selected as an "A" or "B" day the
programme will automatically jump to the next day.
B Days
6. When the last day of the week is active, pressing +, -,
or DAY will move back to the "A" days displayed with no
Wed Sun
selected (fl ashing) days (see image below).
7. Repeat 2 to 6 until all selections have been made.
8. When selections are completed, press the PROG button
to move to event programming.
The time on the programmer must be correct. Some
types have to be adjusted in spring and autumn at the
changes between Greenwich Mean Time and British
Summer Time.
You may be able to temporarily adjust the heating
programme, for example, 'Override' , 'Advance' or 'Boost' .
These are explained in the manufacturer's instructions.
The heating will not work if the room thermostat has
switched the heating off . And, if you have a hot-water
cylinder, the water heating will not work if the cylinder
thermostat detects that the hot water has reached the
correct temperature.
35